[paiand]

прошил через рс232 хупертерминалом а дальше что делать на хупере пишет вот что-
Board: STx7111-Mboard (MB618) [32-bit mode]
info: Disregarding any EPLD


U-Boot 1.3.1 (Nov 15 2010 - 17:57:53) - stm23_0043 - YW 1.0.018 Rel

DRAM: 128 MiB
NOR: 8 MiB
NAND: 512 MiB
In: serial
Out: serial
Err: serial
IdentID : 09 00 0a 00 01 2f e8
Hit ESC to stop autoboot: 3
Force command mode:Select boot (current boot system : spark):
1. spark(up key)
2. enigma2(down key)
3. RS232 Upgrade u-boot(left key)
4. Force into factory mode(right key)
Input Select:
Force rs232 upgrade u-boot, need 524288 Bytes(512kB)
## Ready for binary (ymodem) download to 0x80000000 at 115200 bps...
CCC.xyzModem - CRC mode, 2(SOH)/3(STX)/0(CAN) packets, 5 retries
## Total Size = 0x0000091d = 2333 Bytes

Transmit filesize is not 0x00080000(524288 Bytes)(512kB), please check your cho
iced file
OK
Uncompressing Multi-File Image ... OK
found phy at addres = 1
stmac_phy_get_addr(): id1 = 0x7, id2 = 0xc0f1
stb_id = 90a012fe8
Loading Ramdisk to 80d3c000, length 002c34df ... OK

Starting kernel console=ttyAS1,115200 rw ramdisk_size=6144 init=/linuxrc root=/d
ev/ram0 ip=192.168.0.69:192.168.3.119:192.168.3.1:255.255. 0.0:lh:eth0:off stmmac
eth=msglvl:0,phyaddr:1,watchdog:5000 bigphysarea=4000 nwhwconf=device:eth0,hwadd
r:24:00:0A:01:2F:E8 Manufacture=Spark-Project STB_ID=09:00:0A:00:01:2F:E8 - 0x00
53d000 - 2897119 ...

just for test
^X[MAIN] init finish,errCode=0
[ YWDBASEv_GetData][ 578] error 0x1f40006
[ YWDBL_CommGetVolume][ 288] YWDBLi_CommGetByFldNoWithDefault COMM_VOLUME errTy
pe = 0X1F40006 Unknown
[ YWDBASEv_GetData][ 578] error 0x1f40006
[YWDBLi_ScGetByFieldNo][ 101] YWDBL_GetSysCfgField uFieldNo = 15[YWDBL_ScGetRes
olution][ 496] YWDBLi_ScGetByFieldNo SYSCFG_DEFINITE errType = 0X1F40006 Unknow
n
########################## uiCompSize[0X00AE8BCC]================

это правильно или нет подскажите пожал....